Filtreau Replacement Drum Sieve (Mesh)

Description

Fitting Guide:

• Disconnect the power supply and close the piping.
• Ensure that the water can drain out of the filter.
• Turn the drum by hand until the fastening strip and hose clamps are pointing upwards.
• Now remove the screws from the fastening strip.
• Loosen the hose clamps.
• Remove the drain channel, by unscrewing the two mounting screws at the front.
• Now remove the screen panel and replace it with a new one.
• Tighten the hose clamps and fastening strip again. Then check that the assembly is attached correctly.
• Put the lid back on the housing.
• Now insert the plug in the socket and hold the button for 10 seconds. Now the motor and high pressure pump are activated again. If in doubt please consult a qualified installer.

* This is meant as a guide only and we will take no responsibility for any damage caused in the process of fitting your screen.